We provide functional safety engineering services in accordance with internationally recognised standards, including IEC 61508 and IEC 61511. Our work covers the safety lifecycle, from design and analysis to site verification and testing.
Safety lifecycle
Functional safety is about making sure that when something goes wrong in a process, the safety system does what it was designed to do. That depends on more than good equipment. It depends on correct requirements, sound design, proper installation, and testing that proves the system works as intended. Konisys supports each of these steps.
01
Hazard and risk assessment support identifies what could go wrong and how severe it could be.
02
SIL determination and LOPA studies define how much risk reduction each safety function must provide.
03
A Safety Requirement Specification (SRS) records what each safety function must do.
04
Safety Instrumented System (SIS) engineering and documentation turn the requirements into a design.
05
SIL verification and validation checks that the design meets its targets.
06
SIF testing, field device and final element verification, and inspection and testing prove the installed system works.
07
Functional Safety Assessments (FSA) and compliance audits confirm the work meets the standard.
What we do
We help you define the safety requirements for your process and engineer the systems that deliver them.
Requirements written in a study only count if they are proven on the installed system. Our site services close that loop.
Why Konisys
Our services cover both design and analysis and site verification, so the safety requirements written in the study can be checked on the installed system. Combined with our OT cybersecurity and automation services, you get one team for the whole safety system.
From hazard and risk assessment to SIF testing and compliance audits.
The team that designs can also verify devices and final elements on site.
Safety, cybersecurity, E&I and control system integration work from the same project picture.
FAQ
A Safety Integrity Level (SIL) is a measure of the risk reduction that a safety function must provide. It is set during a SIL determination study and checked during SIL verification.
IEC 61508 is the general standard for the functional safety of electrical, electronic and programmable systems. IEC 61511 applies it to safety instrumented systems in the process industry.
Layer of Protection Analysis (LOPA) is a method for assessing how well the protection layers in a plant reduce a hazard, and what SIL a safety function needs.
A SIS is an engineered set of sensors, logic solvers and final elements that detects a dangerous condition and takes the process to a safe state.
The SRS documents what each safety function must do, how fast it must act and the integrity it must achieve. It is the reference for design, testing and later changes.
Determination sets the SIL target a safety function needs. Verification checks that the designed function actually meets that target.
Yes. Our services include SIF testing, field device and final element verification, and commissioning support.
Related pages
Tell us about your project and we will respond with the right mix of safety, cybersecurity, execution and automation support.